Skoda Slavia PPF Installation: TOUCH T65 Film on Grey Paint
Project

Skoda Slavia PPF Installation: TOUCH T65 Film on Grey Paint

A grey Skoda Slavia has been fitted with clear paint protection film (PPF) across the front end, bonnet, front bumper, rear bumper and sides at the ARI workshop. The film used is TOUCH T65, 8 Mil thick, with a 5-year warranty. This Skoda Slavia PPF installation shows which areas were covered and the film specifications.

Skoda Slavia PPF Installation: TOUCH T65 Film on Grey Paint⛶ 1/10
Vehicle
Skoda · Slavia

Which film was used on this grey Skoda Slavia?

Left-side rear angle view from the front, showing the front end and front bumper being covered with clear PPF film by two people

This job was carried out on a grey Skoda Slavia, with exterior paint protection film (PPF, a clear protective layer) installed at the ARI workshop. The film selected for this installation is TOUCH T65.

TOUCH T65 is a TPU film with an 8 Mil thickness, a tensile strength above 25 MPa and a maximum heat resistance of 110°C. Its surface gloss is above 94 GU, and it is finished with a Nano Ceramic coating.

Which areas of the Skoda Slavia were covered with PPF?

Front-facing view of a black Skoda front end, with the bonnet being covered with clear PPF film while a person in a black shirt stands beside it

Photos from the Skoda Slavia PPF installation show clear film applied to the front end and front bumper, including the grille area and the front headlight units. The bonnet was also covered with clear film during the job.

At the rear and sides, film was applied to the rear bumper and the side panels. This is often one of the largest cost considerations when weighing up PPF for cars, so it is useful to see the coverage clearly. Photos show the installer working on the rear side panels with the boot open.

  • Front end and front bumper
  • Bonnet
  • Rear bumper and side panels

How does the ARI workshop stretch and apply the film?

Rear side angle view of the car, with a technician in a black polo shirt and yellow apron applying clear film to the rear bumper and side of the car, with the door open

During installation, two people hold the film at its edges and stretch it so that it lies evenly across the surface. On areas such as the bonnet, one person in a black shirt pulls and stretches the film at the right-hand edge to keep it flat before it is applied.

On the rear side panels, the installer, wearing a black polo shirt and a yellow apron, works directly to apply the film to the rear bumper and sides. The job was carried out inside the workshop, and the floor is wet in some photos.

Browse another job from our workshop, the Volvo XC40 black PPF installation, to see more of our work in action.

Products Used

Frequently asked questions

Which areas of a Skoda Slavia were covered with PPF in this job?

In this job, the Skoda Slavia had PPF applied to the front end, bonnet, front bumper, rear bumper and sides. These areas are clearly shown in the installation photos taken at the ARI workshop.

Which PPF film was used on this Skoda Slavia?

This Skoda Slavia was fitted with TOUCH T65 film. The film is TPU, 8 Mil thick, finished with a Nano Ceramic coating, and comes with a 5-year warranty according to ARI workshop information.

What are the notable specifications of TOUCH T65 film?

TOUCH T65 is 8 Mil thick, has a tensile strength above 25 MPa, withstands heat up to 110°C and has a surface gloss above 94 GU. Its Nano Ceramic coating helps the film surface hold up better during use.

Does PPF change the colour of a Skoda's paint?

TOUCH T65 is a clear film, designed to sit over the original paint without changing its colour. How well the paint colour and gloss are kept, however, depends on the condition of the paint before installation and on how the film is applied.

How should you care for a Skoda after PPF is applied?

After PPF is applied, wash the car gently and avoid rubbing the film surface hard. Use a pH-neutral car wash solution and avoid harsh chemicals to help the film last and keep its gloss. For a grey Skoda, the film specs and coverage in this job are the key reference points: TOUCH T65 at 8 Mil, applied across the front end, bonnet, front bumper, rear bumper and sides. The specs above give the details needed to judge whether this film suits your car.

Luxury car protected by ARI PPF
Join Our Network

Become an ARI Dealer

Get wholesale pricing, genuine cutting software and factory warranty support. Join the ARI installer network.