Which film was used on the black Lynk&Co 900?

This job used ULTRA U75, a clear PPF product applied as a thin protective layer directly over the paint. The film is made from TPU and measures 8.5 Mil thick, with a tensile strength above 30 MPa and a maximum heat resistance of 110°C.
On the surface side, the film has a gloss level above 140 GU and a Nano Ceramic Ultra coating. According to the manufacturer's official information, the ULTRA U75 line carries an 8-year warranty.
Which panels were covered on the black SUV?

The front end of the vehicle was covered, including the hood and the front bumper. The film also ran continuously from the front bumper over to the headlight assembly, where the installer pulled the film edge to position it.
The side panels, wheel arches and rear of the vehicle are not covered with film in this job, so they fall outside the scope of this installation.
How did the ARI workshop handle the film on black paint?

Two technicians worked together to stretch and smooth the PPF Lynk&Co 900 black over the hood and front bumper. The paint was kept wet while the film was positioned, which helped it settle evenly and made it easier to adjust.
The installer pulled the edge of the clear film over the bumper and headlight assembly, smoothing it from the center outward to reduce air bubbles. Edge alignment was done slowly, and each section was checked before smoothing the next.
How should you care for a car after PPF installation?
After installation, the car PPF film needs time to settle before it is exposed to strong car wash products. Wash the car with clean water and soft tools, and avoid scrubbing hard along the film edges.
Owners should also avoid corrosive cleaning chemicals and keep sharp objects away from the film surface to help the protective layer last longer.
Explore another job our workshop has completed: a Subaru Forester blue PPF installation, carried out with the same care and precision.


