Which film was used on the white Stargazer?

The job used TOUCH TLUMI, a TPU-based paint protection film with a thickness of 8 mil. According to the film data, it has a tensile strength above 25 MPa and a maximum heat resistance of 110°C. The surface gloss is above 94 GU, and the film is finished with a Nano Ceramic coating.
The film carries a 5-year warranty, which is the official figure for the TOUCH TLUMI line and applies to this job.
Which panels were covered on the white car?

In this job, clear PPF for cars was applied to the rear bumper and the rear wheel arches, following the same process the workshop uses on high-impact areas. The front doors and front fenders were also covered.
At the front, the film was stretched and applied to the bonnet and the front bumper, close to the headlight assembly. Each area was aligned and smoothed before the film was bonded to the paint.
How did ARI install the film on the white car?

The car was placed in the workshop, and the installer covered each panel in turn. The film on the bumper and wheel arches was positioned by hand to keep it flat and closely fitted to the paint surface. Hyundai Stargazer white PPF installation requires careful alignment on every detail so the film sits snugly on the paint.
Photos show the white car from several angles, including the front, the side and the rear. The covered areas are visible in the images, while the uncovered parts keep their original white paint.
How should you care for a car after PPF installation?
After installation, wash the car with clean water and a suitable car-care product, and avoid scrubbing the film hard. Limit the use of strong chemicals or brushes with stiff bristles on the covered areas.
On a white car, regular cleaning helps stop dirt from sitting on the film for long. It also helps the film keep a glossy, even appearance over time.
You can also see another Skoda Slavia PPF installation that the ARI workshop carried out under the same service category.


