Which TOUCH T65 film was used on this red Camry?

TOUCH T65 is a paint protection film (PPF) made from TPU with a thickness of 8 Mil. The film has a tensile strength above 25 MPa and withstands a maximum temperature of 110°C, which helps the outer layer stay stable in hot conditions.
A Nano Ceramic coating on the film surface gives a gloss level above 94 GU. The film carries a 5-year warranty under the supplier's terms.
- Material: TPU
- Thickness: 8 Mil
- Tensile strength: above 25 MPa
- Maximum heat resistance: 110°C
- Surface gloss: above 94 GU
- Warranty: 5 years
Which areas of the red Camry were covered with PPF?

For this Toyota Camry red PPF installation, the film was applied to the front end, including the headlight assemblies, the grille and the front bumper. The hood was also covered with clear film, with the edges and the area around the headlights wrapped.
The film continued down the side of the car, to the area in front of the front wheel and the left front door. Photos taken from the side and rear angles show the door and rear bumper area, but the images do not confirm whether film was applied to those spots.
The interior and glass were not part of this installation.
How the installers applied PPF to the car body at ARI

Installers stretch each sheet of wet PPF and lay it onto the paint surface. For a job like this, a common approach is two people working on either side of the car at once: one stretches the film while the other smooths it along the hood edge and headlight area so it lies flat. Because of this labor, the PPF cost for a full-hood install often reflects two skilled technicians on the same panel.
On the side of the car, the installer positions a clear sheet over the left front door and squeegees it from the centre out to the edges. This method helps the film follow the body lines and reduces trapped air bubbles.
How should you care for a Camry after PPF installation?
After PPF is applied, let the car rest outdoors for the period the workshop recommends so the film can settle. When washing, use clean water and a soft cloth, and avoid scrubbing the film surface hard.
The Nano Ceramic coating may make the surface easier to clean, but regular washing is still needed to keep the film glossy.
Browse another job from the ARI workshop, also a PPF Mercedes-Benz GLC 300 black, for a closer look at our approach.


